Description
MATEKSYS VIDEO TRANSMITTER 1.2/1.3GHZ, VTX-1G3SE
-
Powering on without antenna connected will damage the RF module !!!
-
This product requires an amateur radio license to operate legally. Please check your local laws and regulations before purchasing
- 9CH INTL and 2CH US version have identical hardware and layout, 2CH is locked to 1258 & 1280MHz by firmware.
Features & Specifications
- 9CH_INTL version (1080,1120,1160,1200,1240,1280,1320,1360,1258MHz),
- SKU: VTX-1G3SE-9
- RF power output: 0.1mw(0, pit mode), 25mw(1), 200mw(2), 800mw(3)
- CMS control via Tramp protocol variant for 1.3G
- Button control and LED indicators
- Built-in AGC microphone
- 6-36V DC IN (2-8S LiPo)
- Power Consumption: 40mA(0.1mw), 110mA(25mw), 150mA(200mw), 250mA(800mw) @12V IN
- Video format: NTSC or PAL
- Audio Subcarrier: 6.5 MHz & 6.0MHz, onboard microphone on 6.5MHz
- RF Connector: SMA
- Weight: 9g ( w/o antanna)
- Size: board 36*21.5mm
Pads
- + IN-: 6-36V DC input with reverse polarity protection
- VID: Video input
- G: Ground
- 5V: onboard regulator output, Max. 1.5A load on this pad
- A6.0: Audio 6.0MHz input
- RX: CMS control via Tramp protocol
- TX & RX: UART for firmware update
Packing
- 1x 1.2/1.3G Video transmitter VTX-1G3SE-9(INTL version)
- 1x Dipole antenna_SMA, center freq 1240MHz
Settings
- Press button-A to select RF output levels, 0 (blue LED)= 0.1mw pitmode, 1=25mw. 2=200mw, 3=800mw
- Press and hold the button-B for 2 seconds to enter the frequency setting. Frequency LED blinks
- Press the button-B to select the frequency
- When the LED blinks at new frequency, no RF output on this frequency.
- New frequency and output will be enabled if no button action within 3 seconds
CMS control
- Connect “RX” to any spare UART-TX of flight controller, enable “VTX(Tramp) protocol” on corresponding UART.
- Copy and paste following command into CLI of BF4.1 or later release
- vtxtable bands 2
vtxtable channels 8
vtxtable band 1 1G3_A A 1080 1120 1160 1200 1240 1280 1320 1360
vtxtable band 2 1G3_B B 1080 1120 1160 1200 1258 1280 1320 1360
vtxtable powerlevels 3
vtxtable powervalues 25 200 800
vtxtable powerlabels 25 200 800 - When CMS control is enabled, button control will be overridden.
- only 1258 and 1280 can be enabled via CMS control on 2CH version.
- INAV doesn’t support 1.3G CMS control via Tamp protocol for now.
Package Contents ::
- 1 x MATEKSYS VIDEO TRANSMITTER 1.2/1.3GHZ
What others are saying
There are no contributions yet.