Description

DAKEFPV H743 PRO FLIGHT CONTROLLER (STM32H743,Dual IMU,8 UART)

A high-performance H7-series flight controller built around the STM32H743 processor with dual IMUs for redundancy. Supports up to 4S–12S batteries, 8 UARTs for extensive peripheral connectivity, and dual switchable camera inputs — a solid choice for advanced FPV and long-range builds running ArduPilot or Betaflight.

The DAKEFPV H743 Pro is built around the STM32H743 32-bit processor running at 480MHz, giving it plenty of headroom for demanding flight modes, complex mixing, and advanced telemetry logging. It pairs that processing power with dual ICM42688 IMUs for sensor redundancy — a meaningful reliability upgrade over single-IMU boards, since the flight controller can cross-check readings and better reject vibration noise or a failing sensor.

Connectivity is a strong point on this board. With 8 UARTs and a CAN port, you’ve got room to run GPS, telemetry radio, ELRS/CRSF receiver, DisplayPort OSD, and companion computer links simultaneously without fighting for ports. It supports 13 PWM outputs (12 motor outputs plus one LED channel), making it suitable for everything from standard quads up to octocopters and complex VTOL mixing setups.

Battery input runs 4S to 12S, with onboard BEC rails at 3.3V/0.5A, 5V/3A, and a switchable 12V/3A rail specifically for video gear — handy for powering a VTX directly off the board without a separate regulator. Dual switchable camera inputs let you run two cameras (e.g., a standard FPV cam and a HD digital system) and flip between them via GPIO control.

Onboard OSD runs on the AT7456E chip, with simultaneous DisplayPort OSD support configured by default — so it works cleanly whether you’re running analog or a digital HD system. A built-in SPL06 barometer rounds out the sensor package, and 16MB of onboard flash gives you solid room for blackbox logging.

This board does not include a built-in compass — pair it with an external I2C compass module if your build requires one (common on GPS-equipped long-range and autonomous setups).

Compatible firmware: ArduPilot (Copter, Plane), Betaflight
Best for: Advanced FPV freestyle, long-range, and semi-autonomous builds needing extensive peripheral support

SPECIFICATIONS:

• MCU – STM32H743 32-bit processor running at 480 MHz
• IMU – Dual ICM42688
• Barometer – SPL06
• OSD – AT7456E
• Onboard Flash: 16MByte
• 8x UARTs
• 1x CAN port
• 13x PWM Outputs (12 Motor Output, 1 LED)
• Battery input voltage: 4S-12S
• BEC 3.3V 0.5A
• BEC 5V 3A
• BEC 12V 3A for video, gpio controlled
• Dual switchable camera inputs

PACKAGE CONTENTS:

• 1 * DAKEFPV H743 PRO FLIGHT CONTROLLER